Uploud:
ID:
Size:
Width: Px
Height: Px
Source:

Applying The Veneer. Applying the veneer is a simple but time consuming. I will give you as many pointers as I can to aid you in this method. You will have to cut the veneer to fit it to your storage face frame and cabinet end panels. This is fairly straightforward, measure the pieces you will require and cut them to fit. One of the best ways to cut veneer is by using a good sharp utility silverware and a metal smooth edge. You will want to use a sacrificial sheet of plywood or perhaps mdf under your cutting. Once cutting for the face frame pieces of your cabinets always try to be as accurate as possible so you do not have to cut the veneer when it is positioned on the cabinets, its fine if it's a 1/32 half inch over and you have use a corner plane or a sanding engine block to fine tune it, no more than that you will have to try to cut it flush and that can cause problems, so finely-detailed is important here. Once you have every one of the cabinet face frames and ends covered you can begin installing your new cabinet entrances.

Image Editor

Veterinariancolleges-

You can edit this image using this Veterinariancolleges Tool before save to your device

You May Also Like